The 3DCut mechanism

It cuts the peppercorn. It does not crush it.

3DCut is Alexander's three-stage grinding mechanism. In the pepper mill it is all metal: pressed zinc alloy on a steel rod. Cracking teeth split each peppercorn, cutting teeth shear the halves, and fine ridges grind the pieces to the size set by the adjustment screw underneath, so the corn is cut rather than crushed. Most mills use a mechanism about 20 mm across; the 9" Alexander pepper mill has an all-metal one of 38 mm, which grinds large amounts quickly.

Most grinders flatten the corn, bruising its oils before they reach the plate. The 3DCut mechanism works in three stages, each with its own teeth.

Cross-section of the 3DCut grinding mechanismA cut-away of the lower mill body. Peppercorns sit above a zinc alloy cone on a steel rod with three bands of teeth: large cracking teeth at the top, cutting teeth in the middle, and fine grinding ridges at the bottom, where ground pepper falls out.123
  1. Crack

    Large teeth at the top of the cone grab each peppercorn and split it in half, instead of squashing it against a wall.

  2. Cut

    The halves fall into a band of smaller cutting teeth that shear them into pieces, keeping the oils inside the fragments.

  3. Grind

    Fine ridges at the base grind the pieces to the thickness set by the adjustment screw. The pepper leaves the mill the moment it reaches size.

Try the grind setting

Not turned yet.

Press the button, or focus it and press Enter, to turn one full revolution.

FineCoarse
Medium: the setting most cooks leave it on.
The three stages in words
StageWhat happens
CrackLarge teeth at the top of the cone grab each peppercorn and split it in half, instead of squashing it against a wall.
CutThe halves fall into a band of smaller cutting teeth that shear them into pieces, keeping the oils inside the fragments.
GrindFine ridges at the base grind the pieces to the thickness set by the adjustment screw. The pepper leaves the mill the moment it reaches size.

Try it

Turn the crank. Choose your grind.

Pick a setting, then turn the crank. The plate shows what each setting gives you, from fine dust for a sauce to cracked pepper for a steak.

Your millNot turned yet
Grind setting

Best for

the setting most cooks leave it on.

Not turned yet

The 3DCut mechanism

Adjusting the grind

On the pepper mill, turn the adjustment screw under the grinding mechanism, at the bottom of the mill. Turn it a little at a time and test until the pepper comes out the size you want. The setting holds until you change it.

Care

Why the salt mill is different

The pepper mechanism is all metal: pressed zinc alloy on a 10 mm steel rod, adjustable from fine to coarse. The salt mill uses the same 3DCut design in food-safe plastic on an 8 mm stainless steel shaft, with a plastic lining inside the body, because salt corrodes ordinary steel. The maker notes that salt mills need extra care to prevent oxidation caused by the salt, so keep the salt mill dry and wipe away any salt on the body.

Made to be handed down.

Solid brass or copper and an all-metal pepper mechanism, finished by hand. Buy it once, then pass it on.